John Lewis JLBIWIC01 User Manual download pdf (Page 16)

Problem Possible cause Solution

Water flows on the rear plate of

the refrigerator.

During the automatic defrosting

process, frost melts on the rear

plate.

This is correct.

Water flows inside the wine cellar. The water outlet is clogged. Clean the water outlet.

Food products prevent that wa-

ter flows into the water collector.

Make sure that food products do not

touch the rear plate.

DEMO appears on the display. The appliance is in demonstration

mode.

Keep the Alarm pressed for approxi-

mately 10 seconds until a long sound

is heard and display shuts off for a

short time.

The temperature in the wine cellar

is too low/too high.

The temperature regulator is not

set correctly.

Set a higher/lower temperature.

The door is not closed correctly. Refer to "Closing the door".

The food products' temperature

is too high.

Let the food products temperature

decrease to room temperature be-

fore storage.

Many food products are stored at

the same time.

Store less food products at the same

time.

The door has been opened often. Open the door only if necessary.

If the advice does not lead to the

desired result, call the nearest

brand-mark service.

Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the After Sales Service.

Replacing the lamp Wine

Cellar

1. Disconnect the mains plug from the mains

socket.

2. Remove the lamp cover by pressing it inwards

with a tool (e.g. screwdriver) to free the rear

side hookings.

3. At the same time, free the middle hook and

slide off the cover in the direction of the

arrows.

Wine cellar User Manual16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

John Lewis JLBIWIC01 User Manual Page 16

Comments to this Manuals

Related products and manuals for Wine coolers John Lewis JLBIWIC01