John Lewis JLTDH16 User Manual download pdf (Page 29)

Installation

Appliance positioning

• The tumble dryer must be installed in a clean

position, where dirt does not collect.

• Air must flow freely around the appliance.

Make sure that the front airflow slots in the

bottom of the appliance are not blocked .

• To keep vibration and noise at the minimum,

when the tumble dryer operates, it must be

put on a stable and flat surface.

• When the appliance is put in its permanent

position, check if is fully level with the aid of a

spirit level. If it is not, adjust the feet until it is.

• Do not remove the feet. Do not decrease the

floor clearance through thick carpets, bar of

wood or equivalent. This can increase the

heat which can cause interference with the

operation of the appliance.

Important!

• The temperature of the hot air which

occurs in the tumble dryer can

increase to 60 °C. The appliance must

not be installed on the floor which is

not resistant to high temperatures.

• When the tumble dryer operates, the

room temperature must not be lower

than +5 °C and higher than +35 °C.

This can cause unwanted effect on the

performance of the appliance.

• If it is necessary to move the appliance,

it must be moved vertically.

• The appliance must not be installed

behind a lockable door, a sliding door,

a door with a hinge on the opposite

side to that of the appliance in such a

way that a full opening of the tumble

dryer is restricted.

Unpacking

Caution!

Before use all parts of the transport packaging

must be removed.

To remove the polystyrene blockages:

1. Open the load door.

2. Pull plastic hose with the polystyrene

blockages out from the drum.

It is possible to adjust the height of the tumble

dryer. To do that adjust the feet (see picture).

15mm

Tumble Dryer user manual 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

John Lewis JLTDH16 User Manual Page 29

Comments to this Manuals

Related products and manuals for Tumble dryers John Lewis JLTDH16