John Lewis JLWM1604 User Manual download pdf (Page 32)

Warning! Installation should

comply with local water

authority and building

regulations’ requirements.

The appliance must be

connected to a cold water

supply.

A minimum water pressure of 0.05

MPa (0.5 bar) is required for safe

operation of the appliance.

If you cannot make the cold water

connection direct from the rising

mains, you may be able to operate the

appliance from your cold water

storage system.

There should be a minimum vertical

distance of 5.02 m (16.5 ft) between

the appliance’s inlet and the bottom of

the water storage tank.

Water drainage

This appliance is designed to be permanently

plumbed into your home's drainage system

using one of the following methods.

1. Into a drainage standpipe

Firstly form a hook in the end of the drain hose

using the “U” piece” supplied.

1

Place the drain hose into your standpipe,

which should have an internal diameter of

approximately 38 mm thus ensuring there is

an air break between the drain hose and

standpipe.

38 mm (½”)

30 cm (12”)

When discharging into a standpipe ensure that

the top of the standpipe is no more than 90

cm (35.4'') and no less than 60 cm (23.6'')

above floor level.

3 pin

Min. 60 cm (23.6”)

Min. 90 cm (35.4”)

The drain hose may be extended to a

maximum of 4 metres. An additional drain

hose and joining piece is available from your

local Service Force Centre. The joining piece

must have an internal diameter of 18 mm.

If your drain hose looks like this (see below)

you do not require the “U” piece”. Just push

the hose firmly in to the standpipe.

2. Onto a sink outlet spigot.

32

1 ... 31 32 33 ... 44

Comments to this Manuals

No comments