John Lewis JLDWW905 User Manual download pdf (Page 7)

Unpacking

● Remove all packaging before positioning the machine.

● If possible,position the machine next to a water tap and a

drain.

Water supply connections

We recommend that this dishwasher is connected to your cold

water supply.

For making the connection itself,the coupling nut fitted to the

machine’s supply hose is designed to screw onto either a 3/4"

inch gas thread spout or to a purpose made quick-coupling tap

such as the Press-block.

The water pressure must be within the limits given in the

"Technical specifications".Your local Water Authority will advise

you on the average mains pressure in your area.

The water inlet hose must not be kinked,crushed,or entangled

when it is being connected up.

The dishwasher features fill and drain hoses which can be turned

either to the left or the right to suit the installation by means of

the locknut.The locknut must be correctly fitted to avoid

water leaks.(Important! NOT all models of dishwashers have

fill and drain hoses provided with locknut.In this case,this kind of

facility is not possible).

If the machine is connected to new pipes or pipes which have not

been used for a long time,you should run the water for a few

minutes before connecting the inlet hose.

DO NOT use connection hoses which have previously

been used for an old appliance.

This appliance has been fitted with safety features which will

prevent the water used in the appliance from returning back into

the drinking water system.This appliance complies with the

applicable plumbing regulations.

Water inlet hose with safety valve

After connecting the double-walled water inlet hose,the safety

valve is next to the tap.Therefore the water inlet hose is only

under pressure while the water is running.If the water inlet hose

starts to leak during this operation,the safety valve cuts off the

running water.

Please take care when installing the water inlet hose:

● The electrical cable for the safety valve is in the double-

walled water inlet hose.Do not immerse the water inlet hose

or the safety valve in water.

● If water inlet hose or the safety valve is damaged,remove the

mains plug immediately.

● A water inlet hose with safety valve must only be replaced by

a specialist or by the Service Force Centre.

● Place the water inlet hose in such a way that it is never higher

than the bottom edge of the safety valve.

Warning!

Dangerous voltage

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Comments to this Manuals

No comments

John Lewis JLDWW905 User Manual Page 7

Comments to this Manuals

Related products and manuals for Dishwashers John Lewis JLDWW905