John Lewis JLDWW905 User Manual download pdf (Page 8)

Fitting under a counter

(kitchen worktop or sink)

By removing the machine’s worktop,you can install it under a

close fitting sink unit or a pre-existing top,providing the

dimensions of the recess correspond to those shown in the

picture.

Proceed as follows:

Remove the machine’s worktop by unscrewing the two rear

retaining screws,pull the worktop from the back of the machine

and slide out the front slots,lifting the worktop.

Insert the machine after adjusting height and levelling with the

adjustable feet.When inserting the machine,ensure that the

water inlet and drain hoses are not kinked or squashed.

During all operations that involve accessibility to internal

components the dishwasher has to be unplugged.

Be sure that once the appliance has been installed,it is easily

accessible for the service engineer in the event that a repair is

required.

If the dishwasher is later used as a free-standing appliance,the

original worktop must be re-mounted.

The plinth on free-standing appliances is not adjustable.

Levelling

Good levelling is essential for correct closure and sealing of the

door.

When the appliance is correctly levelled,the door will not catch

on either side of the cabinet.

If the door does not close correctly,loosen or tighten the

adjustable feet until the machine is perfectly level.

Water outlet hose connection

The end of the drain hose can be connected in the following

ways:

1. To the sink outlet spigot,securing it to the underside of

the work surface.This will prevent waste water from the

sink running into the machine.

2. To a stand pipe provided with vent-hole,minimum internal

diameter 4 cm.

The waste connection must be at a height of between 30 cm

(minimum) and 100 cm (maximum) from the bottom of the

dishwasher.

The drain hose can face either to the right or left of the

dishwasher

Ensure the hose is not bent or squashed as this could prevent or

slow down the discharge of water.

The sink plug must not be in place when the machine is draining

as this could cause the water to syphon back into the machine.

If you use a drain hose extension it must be no longer than 2

metres and its internal diameter must be no smaller than the

diameter of the hose provided.

Likewise the internal diameter of the couplings used for

connections to the waste outlet must be no smaller than the

diameter of the hose provided.

Important!

Our appliances are supplied with a security device to protect

against the return of dirty water back into the machine.

If the spigot of your sink has a "no return valve" incorporated this

can prevent the correct draining of your dishwasher.

We therefore advise you to remove it.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

John Lewis JLDWW905 User Manual Page 8

Comments to this Manuals

Related products and manuals for Dishwashers John Lewis JLDWW905