John Lewis JLBIGH603 User Manual download pdf (Page 10)

4. With a thin screwdriver, adjust the bypass

screw position (A).

5. If you change:

• from natural gas G20 20 mbar to liquid gas,

fully tighten the bypass screw in.

• from liquid gas to natural gas G20 20 mbar,

undo the bypass screw approximately 1/4

of a turn (1/2 of a turn for Multi Crown

burner).

6. Reassemble the gasket and the knob.

Warning! Make sure the flame

does not go out when you

quickly turn the knob from

the maximum position to the

minimum position.

Electrical connection

• Do not pull the mains cable to disconnect the

appliance. Always pull the mains plug (if

applicable).

• The appliance must not be connected with an

extension cable, an adapter or a multiple

socket. There is a risk of fire.

• Do not let the power cable to heat up to a

temperature of more than 90° C. The cable

should be guided by means of clamps fixed to

the side of the cabinet, in order to avoid any

contact with the equipment beneath the

cooktop.

• Make sure that there is access to the mains plug

after the installation.

Electrical Requirements

Permanent electrical installation must agree with

the latest I.E.E. Regulations and local Electricity

Board regulations. For your own safety the

installation must be done by a qualified

electrician (e.g. your local Electricity Board, or a

contractor who is on the roll of the National

Inspection Council for Electrical Installation

Contracting [NICEIC]).

Hob User Manual

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

John Lewis JLBIGH603 User Manual Page 10